What Southlake requires for a roof replacement
Southlake is specific about roof replacements. The city’s own handout says the International Residential Code requires a building permit, the contractor has to be registered with the city, and the job ends with a final inspection requested online. Knowing the sequence up front keeps the job from stalling at the end.
From the city’s roof replacement handout (February 2026), the steps run like this:
- The roofing contractor registers with the City of Southlake as a general contractor.
- The building permit is applied for online and issued before work starts.
- The permit card is posted at the house in plain view from the road.
- When the roof is finished, the contractor requests a final inspection, either by photos or in person.
- For a photo inspection, the photos show the house address, every roof elevation from the ground, and the vent terminations outside and in the attic.
- For an in-person inspection, the inspector checks the roof from the ground and the attic for appliance vents knocked loose during the work, so someone needs to be home.
We tell you at the estimate which inspection route we plan to use and, for an in-person visit, work out a time when you can be there.
The city’s own advice on hiring a roofer
Southlake’s handout ends with practical advice for homeowners: check references, look closely at the work history of roofers who are from out of the area or out of state, and be suspicious of any contractor who asks for payment up front. After a big hailstorm, that advice matters more than usual.
Our only office is on Little Road in Arlington. We were founded in 2017, we are insured, and we are registered with the City of Arlington. Texas does not license roofing contractors, so insurance, city registration and a local address are the things to ask any roofer for. Our why hire us page covers the rest, including our 5-year labor warranty, and our payments page explains financing.
Large roofs and the materials they call for
Southlake homes tend to be large, often on big lots, with complex rooflines that have many planes, valleys and wall junctions. A roof like that is a significant part of how the house looks from the street, and it presents a lot of surface to hail.
For many Southlake owners, replacement is the time to choose the material deliberately rather than repeat what the builder installed. We regularly price three directions: a designer or architectural shingle for appearance, a Class 4 impact-resistant shingle for hail resistance, and metal roofing where the house and any HOA rules allow it. Each is measured on site, and the flashing and valley work is itemized, because on a complex roof that is where the labor goes.
After a storm
Hail damage on a large Southlake roof is easy to miss from the ground and easy to underestimate from a ladder. We walk every slope, photograph bruised and cracked shingles, dented vents and flashing, and check the attic for any water that has already come in.
If the damage supports a claim, those dated photos become the basis for the insurance claim, and we meet the adjuster on the roof. If the roof came through fine or needs only a small repair, we say so. Our storm damage page explains the full process.
How far Southlake is from Arlington
Southlake is about 30 miles from our office in southwest Arlington, usually 35 to 45 minutes via Highway 360 and Highway 114 depending on traffic. We book Southlake inspections by appointment and allow enough time on site to walk a large roof properly.
We also serve neighboring Grapevine, Colleyville and Keller. For what drives the price of a new roof, see our DFW roof replacement cost guide. Call (817) 754-9484 to book a free inspection.